 |
|
|
|
| GAMCOLOR® - MATERIAL SAFETY DATA SHEET - GAMSPUN, GAMVEL 45 |
|
 |
|
|
| GAMPRODUCTS, INC |
Tel # 323-935-4975 |
| 4975 West Pico Boulevard |
Date: 03/09 |
| Los Angeles, CA 90019 |
|
 |
| |
|
| PRODUCT NAME: |
GamSpun™ 32, 35, 38 and GamVel™ 45 |
| CHEMICAL NAME: |
Polyester Fabric |
| EMERGENCY OVERVIEW: |
None of the components in this material are considered hazardous. |
| ROUTE OF EXPOSURE-SKIN: |
Possible mechanical irritation. |
| ROUTE OF EXPOSURE-INGESTION: |
N/A |
| ROUTE OF EXPOSURE-INHALATION: |
Not expected to be a problem being that this product is an inert solid. |
| HMIS RATINGS: |
Health: 0 Fire: 1 Reactivity: 0 Personal Protection: A |
| Hazard Scale: 0=Minimal 1= Slight 2=Moderate 3=Serious 4=Severe *=Chronic Hazard |
|
HMIS RATINGS:
| |
|
|
|
| CAS # |
CAS # |
PERCENT |
|
| 25038-59-9 |
Polyester |
>85% |
|
| 25640-14-6 |
Co-Polyester Resin |
<15% |
|
| COMPONENT INFORMATION: This product is not hazardous according to the criteria specified in 29CFR 1910.1200 (Hazard Communication Standard). This product is considered an article and does not require an MSDS. |
| FIRST AID-SKIN: |
Wash affected area with soap and water. |
| FIRST AID-EYE: |
Rinse eyes with water for at least 15 minutes. If irritation persists, contact a physician. |
| FIRST AID-INGESTION: |
N/A |
| FIRST AID-INHALATION: |
N/A |
| FIRST AID-NOTES TO PHYSICIAN: |
No health conditions aggravated by exposure are identified. Contact the poison control center if any problem occurs. |
| SPECIFIC GRAVITY: |
N/A |
| |
|
|
|
| FLASH POINT: |
N/A |
METHOD USED: |
N/A |
| AUTO IGNITION: |
N/A |
FLAMMABILITY CLASSIFICATION: |
N/A |
| LOWER EXPLOSIVE LIMIT (%): |
N/A |
UPPER EXPLOSIVE LIMIT (%): |
N/A |
| GENERAL FIRE HAZARDS: |
Solid material may burn upon extended exposure to open flames. |
| HAZARDOUS COMBUSTION PRODUCTS: |
Upon decomposition this product may emit carbon dioxide, carbon monoxide and/or low molecular weight hydrocarbons. |
| EXTINGUISHING MEDIA: |
Water spray, foam, carbon dioxide, or dry chemical |
| FIRE FIGHTING EQUIPMENT / INSTRUCTIONS: |
As in any fire, wear a self-contained breathing apparatus and full protective gear. |
| NFPA RATING: |
Health: 0 Fire: 1 Reactivity: 0
Hazard Scale: 0=Minimal 1=Slight 2=Moderate 3=Serious 4=Severe |
|
| ACCIDENTAL RELEASE MEASURES |
|
| STORAGE PROCEDURES: |
Sweep waste fabric into a pile. |
| CLEAN-UP PROCEDURES: |
Sweep waste fabric into a waste container and recycle, incinerate or land fill in conformity with local disposal regulations. |
| EVACUATION PROCEDURES: |
N/A |
| SPECIAL PROCEDURES: |
N/A |
| |
|
| STORAGE PROCEDURES: |
Store material in cool (below 140°F) warehouse that is equipped with a sprinkler system. Ensure product is not stacked too high. Store product off the floor to prevent water damage. |
|
| EXPOSURE CONTROLS / PERSONAL PROTECTION |
|
| |
|
|
| COMPONENT |
CAS# |
EXPOSURE LIMITS |
| Polyester |
25038-59-9 |
Manufacturer Limit: 10mg/m3, 8 hour TWA, total dust 10mg/m3, 8 hour TWA, respirable dust |
| Co-Polyester Resin |
25640-14-6 |
Manufacturer Limit: 10mg/m3, 8 hour TWA, total dust 10mg/m3, 8 hour TWA, respirable dust |
| ENGINEERING CONTROLS: |
|
Normal room ventilation is usually adequate. |
| PERSONAL PROTECTIVE EQUIPMENT: |
|
| PERSONAL PROTECTIVE EQUIPMENT-EYES/FACE: |
None usually required |
| PERSONAL PROTECTIVE EQUIPMENT-SKIN: |
None usually required |
| PERSONAL PROTECTIVE EQUIPMENT-RESPIRATORY |
None usually required |
| PERSONAL PROTECTIVE EQUIPMENT-GENERAL: |
Follow individual plant safety rules. |
|
| CHEMICAL AND PHYSICAL PROPERTIES |
|
| APPEARANCE: |
White Fabric |
ODOR: |
Essentially Odorless |
| PHYSICAL STATE: |
Solid |
pH: N/A |
|
| VAPOR PRESSURE: |
Not Applicable |
VAPOR DENSITY: |
N/A |
| BOILING POINT: |
N/A |
MELTING POINT: |
>165°C |
| SOLUBILITY (H2O): |
Negligible |
SPECIFIC GRAVITY: |
1.3-1.6 |
| EVAPORATION RATE: |
N/A |
PERCENT VOLATILES: |
NIL |
| PACKING DENSITY: |
N/A |
|
|
| |
|
|
|
|
| CHEMICAL STABILITY & REACTIVITY INFORMATION |
|
| |
|
| CHEMICAL STABILITY: |
Stable under ordinary conditions of use and storage. |
| CONDITIONS TO AVOID: |
Combustible when exposed to open flames. |
| INCOMPATIBILITY: |
None Known |
| HAZARDOUS DECOMPOSITION: |
Carbon monoxide, carbon dioxide and/or low molecular weight hydro carbon may be emitted upon decomposition. |
| HAZARDOUS POLYMERIZATION: |
Will not occur. |
| |
|
| TOXICOLOGICAL INFORMATION |
| |
|
| ACUTE AND CHRONIC TOXICITY |
|
| GENERAL PRODUCT INFORMATION: |
No components of this product are known to be hazardous according to the criteria specified in 29CFR1910.1200 (Hazard Communication Standard). |
| CARCINOGENICITY |
|
| GENERAL PRODUCT INFORMATION: |
Product is considered non-hazardous. |
| EPIDEMIOLOGY: |
No information available. |
| NEUROTOXICITY: |
No information available. |
| MUTAGENICITY: |
No information available. |
| TERATOGENICITY: |
No information available. |
| OTHER TOXICOLOGICAL INFORMATION: |
Specific toxicity testing has not been performed on this product. Hazard evaluation is based on information from similar products, raw material data, and technical literature. |
| |
|
| DISPOSAL INSTRUCTIONS: |
Dispose of container and unused contents in accordance with federal, state and local requirements. Processing, use or contamina- tion of this product may change the waste management options. |
| TRANSPORTATION INFORMATION |
| |
|
| TRANSPORTATION REGULATIONS: |
Product is not regulated for transportation. |
| |
|
| TRANSPORTATION INFORMATION |
| |
|
|
|
|
|
|
|
| US FEDERAL REGULATIONS |
|
|
|
|
|
| GENERAL PRODUCT INFORMATION: |
This material meets the criteria of 21CFR177.1630 of the FDA food contact regulations. |
| COMPONENT ANALYSIS-FEDERAL: |
|
|
|
|
|
|
| COMPONENT |
CAS# |
SARA 302
(40CFR355 Appx A) |
SARA 313
(40CFR372.65)
|
CERCLA
(40CFR302.4) |
|
| Polyester |
25038-59-9 |
No |
No |
No |
|
|
| Co-Polyester Resin |
25640-14-6 |
No |
No |
No |
|
|
| NK-Not Known |
|
|
|
|
|
|
|
| STATE REGULATIONS |
|
|
|
|
|
|
| GENERAL PRODUCT INFORMATION: |
|
Other state regulations may apply. Check individual state requirements. |
|
|
| COMPONENT ANALYSIS-STATE: |
|
The following components appear on one or more of the following state hazardous substances list: |
|
|
| COMPONENT |
CAS# |
CA |
FL |
MA |
MN |
NJ |
PA |
| Polyester |
25038-59-9 |
No |
No |
No |
No |
No |
No |
| Co-Polyester Resin |
25640-14-6 |
No |
No |
NK |
No |
No |
No |
| NK-Not Known |
|
|
|
|
|
|
|
| COMPONENT ANALYSIS-WHMIS IDL: |
No components are identified under the Canadian Hazardous Products Act Ingredient Disclosure List. |
| ADDITIONAL REGULATORY INFORMATION |
|
|
|
| COMPONENT ANALYSIS-INVENTORY: |
|
|
|
|
| COMPONENT |
CAS# |
TSCA |
DSL/NDSL |
EINECS |
|
|
|
| Polyester |
25038-59-9 |
Yes |
Yes |
Yes |
|
|
|
| Co-Polyester Resin |
25640-14-6 |
Yes |
Yes |
Yes |
|
|
|
| |
|
|
|
|
|
|
|
| |
|
Material for this MSDS was taken from MSDS’s for raw materials.
MSDS HISTORY: Format revised 1/04; Corrections made to Section 9 2/23/05; Updated contact information 8/24/05; Updated information and changed name 12/12/06; Update formatting 6/20/07; Change contact name 8/9/07.
DISCLAIMER OF EXPRESSED AND IMPLIED WARANTIES: The information in this document is believed to be correct as of the date issued. HOWEVER, NO WARRANTY OF MERCHANTABILITY, FITNESS FOR ANY USE, OR ANY OTHER WARRANTY IS EXPRESSED OR IS TO BE IMPLIED REGARDING THE ACCURACY OR COMPLETENESS OF THIS INFORMATION, THE RESULTS TO BE OBTAINED FROM USE OF THIS INFORMATION OR THE PRODUCT, THE SAFETY OF THIS PRODUCT, OR THE HAZARDS RELATED TO ITS USE. This information and the product are furnished on the condition that the person receiving them shall make his or her own determination as to the suitability of the product for his particular purpose and on the condition that they assume the risk of his use thereof. THIS PRODUCT IS CONSIDERED AN ARTICLE AND DOES NOT REQUIRE A MATERIAL SAFETY DATA SHEET (MSDS). |
|
| |
|
|
 |
|
|
