Remote controller relay for loads up to 4000 watts, 120/230 VAC, DC models also available
Rugged inclosure can be pipe hung using C-Clamp or wall mounted
Load Power Input and Output through 12 inch pigtails with choice of male and female connectors
Low voltage control from the GAM GO-LITE™ Controller
Control one or multiple relays individually or in groups
Use independent or in conjunction with GO-LITE™ Cubes
How it works:
Connect the Remote Relay to your choice of power input. This connection is made through the 12 inch pigtails extending
from the side of the Remote Relay enclosure. You may select a unit with bare wires or with specific connectors such
as Edison, Stage Pin, Twist Lock, etc. Low voltage 6-wire telephone cable goes from the GO-LITE™ Controller RJ-25
receptacle marked "A" to receptacle marked "IN" on the Relay Box.
You can also use GAM GO-LITE™ cubes anywhere in the sequence should you wish to use the Remote Relay with the
cueing lights in the same loop. Using the control switch located in the upper right hand corner of the Relay Box, select one
of the color channels; white, red, blue or green to address the Relay. The switch also has an "Off" position and a "Test"
position which enables you to switch the relay off so it will not respond to a signal or to test the relay to see if it is working.
