Click to view separate GOES Non-Indexing Twinspin™ Operating Instructions or download PDF GOES 1535 Non-Indexing Twinspin Operating Instructions

There are two models of the GOES TwinSpin™. One is indexing and one is non-indexing. If you have a non-indexing TwinSpin™ (TS-5222) , you can control it with a DMX signal. If you do not have a DMX signal, you can set the control to“standalone” and it will operate whenever the power is turned on. Either model requires a GAM power supply.

The Non-Indexing TwinSpin™ can be operated by a DMX signal. The channel setting on the power supply should be set to 1 for the mode switch, then the following channel switches can be set to the channel of your choice. For example, if you are going to use channel 1 on your dimmer board, then the sequence setting will be 1-0-0-1. In this mode setting your DMX signal will start the TwinSpin™. The Dowser, if used, will be on the next higher channel automatically (channel 2). With this above setting, your selected channel will control the TwinSpin™ as follows:

The mode and channel set switches can be set for automatic sequence of pattern rotation. The selected sequence or continuous rotation will start when the unit is powered and it will stop when power is turned off.

Standalone Modes Mode Switch = 0, 5, 6, & 7. No DMX required. Power supply only.
These are preprogrammed effects with parameters that can be set by the control switches as follows:

Standalone Modes Mode Switch = 0, 5, 6, & 7. No DMX required. Power supply only.
These are preprogrammed effects with parameters that can be set by the control switches as follows:

The non-indexing model has all the same control functions as the indexing model except the non-indexing model selects a random position as the home point of the index. The indexing model sets itself to a fixed home position (so it knows its position).